Topics Covered: -Setting up a new model -Disabling LD and RD -Disabling Pitch and Throttle Curve Points -Disabling Trims -Navigating Menus Quickly -Simplifyi…
Related Posts
17 Comments on “Futaba 14SG Radio Programming Tips”
Comments are closed.
The Entrepreneur's Hangout
Do you have any information or tips on how to setup a EzUHF radio with my
Futaba 14SG? It would be greatly appreciated.
So why is there no tutorials on the T10CG radio? I wish Futaba or somebody
would do a programming vid on that radio… as many as there are, one would
think something would exist.
C’mon Futaba… I dare you!
Nice video Darrick… Needed this for setting up my radio. Thanks
you may add telemetry speech setup
great but talk tooo low
Thanks…very helpful
Thanks Darrick, very helpful!!
Can’t here you
My notes from watching video might be useful to others.
1:45 — Swash Type — VBAR, YGE750 and others are normally H1
2:20 — Transmission type
FasstMulti – No Telemetry
Fasstest 12 – SBus Telemetry
FASSTest 14 – External telemetry
Start from top and pick first one that meets needs. As you move down
list latency increases
5:20 — Disable dials (LD/RD)
By default these change pitch and throttle curves
Select: Model->Pitch Curve and Change LD to INH
Model->Throttle Curve and Change RD to INH
8:20 — Simplify 5 point throttle curve to 2 point
Model->Throttle Curve
Select Points 4, 3, and 2 and hold Ret until value changes to —
Holding Ret again will re-enable
10:00 – Diable Trims
Linkage->Functions
Select trim and then select — as switch for that trim function
Repeat for each channel, as desired
12:10 – Use S1 to scroll through menus
13:40 – Use same expo for all conditions
By default separate expo for each flight mode
Model->Dual Rate
Change condition to “switch” but do not assign a switch
Repeat for each channel, as desired
16:00 – Throttle hold
Condition->Hold is — by default (not enabled)
Assign to desired switch. “G” is common choice with operation set to
Off-On-On
IU3 can also be disabled here.
18:10 – Model Select at Startup
System->Start Select
Model vs Quick Select. Use model to see list everytime.
Set to ‘always’ to force prompt each time.
20:20 – Timer
Key point is switch assignment must be set. Derrik ties to IU.
Well done, good presentation…..thanks mate..!
Great video man!
Nice! Very helpful!
cette radio est une grosse merde !
il faut un récepteur pour chaque modèles un gouffre pognon !
Nice video Darrick… Needed this for setting up my radio. Thanks
FUTABA T14SG開機出現問題,開機就出現POWER MODE不知發生什麼事?